DuraOmni Wheel

This Heavy Duty DURAble omni wheel is a vast improvement over our older 6" omni wheels and other wheels on the market. The body has been totally redesigned with durability and mobility in mind. The design intent is to provide a smooth roll along with the ability to handle impacts very well.

The body is made from black polycarbonate, while the rollers are each molded with a nylon core and TPU tread. These rollers spin smoothly on a captured dowel pin.
Usage With Axle and Hub:

• If you wish to drive this wheel with an axle and hub, you can pick your hub by fitting any of the AndyMark hubs to this wheel. Hubs are not included with this wheel. If this is your choice, then no bearing is needed. To install a hub onto this wheel, use #10-24x3/4 thread forming screws.

Usage With Sprockets and Bearings:

• If you wish to drive this wheel with a sprocket, then the sprocket needs to be attached to the side of the wheel with #10-24x3/4 thread forming screws. You will also need to press ball bearings into the wheel so that it may spin on a shaft or bolt. The ball bearing must have a 1.125 in. od. For a 1/2 in. shafts, use am-0181. For a 3/8 in. shafts use am-0209.